I decided to try my hand at the fibergalls tips for the rudder. I'm not real pleased with the job I did on the bottom tip. In particular I think I could have done a better job on the forward end where it firs around the rudder horn. I'm thinking of calling Vans and ordering another bottom tip. I took several pictures of the rudder and the tips. Note that I decided to use "floating" nut plates to secure the bottom tip.

Shown here are several photos taken from the time the boxes arrived through the construction of the tail kit components.

Gallery pages: < 1 2 3 4 5 6 > >>

< 25 of 199 >

> All of the HS components have been deburred and are ready for priming.

> It was a nice day outside so I decided to work on the VS in the garage.

> The VS components after they have been deburred and are ready for priming.

> I decided to adde the lightening holes. I purchased a metal hole saw from LOWES and used it for the 1.5 inch holes. I purchased a fly cutter and used if for the 2 inch holes. Both the hole saw and the fly cutter worked very well. Be sure the stiffener is clamped to the drill press table, go slow, and use machine oil.

> I decided to try my hand at the fibergalls tips for the rudder. I'm not real pleased with the job I did on the bottom tip. In particular I think I could have done a better job on the forward end where it firs around the rudder horn. I'm thinking of calling Vans and ordering another bottom tip. I took several pictures of the rudder and the tips. Note that I decided to use "floating" nut plates to secure the bottom tip.

I decided to try my hand at the fibergalls tips for the rudder. I'm not real pleased with the job I did on the bottom tip. In particular I think I could have done a better job on the forward end where it firs around the rudder horn. I'm thinking of calling Vans and ordering another bottom tip. I took several pictures of the rudder and the tips. Note that I decided to use "floating" nut plates to secure the bottom tip.